pharmahoogl.blogg.se - Roborock moving dock

The robot will automatically shut down if left in sleep mode for more than 12 hours.The robot will not go to sleep when it is charging.If the robot is paused for over 10 minutes, it will go to sleep, and the power indicator will flash every few seconds. Note: Placing a paused robot on the dock manually will end the current task.

When the robot is paused, press the button to continue vacuuming, or press the button to continue mopping. When the robot is running, press any button to pause it, or press the button to send it back to the dock. Note: The robot cannot be turned off when it is being charged. Press and hold the button to turn off the robot and complete the cleaning cycle.

The power indicator will turn on and the robot will enter standby mode. Press and hold the button to turn on the robot. In so doing, the robot cleans all zones one by one, efficiently cleaning the house. It splits a room into zones, first draws out zone edges, and then fills the zone in a zigzag pattern. The robot will plan its cleaning route according to its scan of the room. (You may disable the air-dry feature in the app.) After the cleaning, it starts charging and air-dries the mop. Upon completion of mopping, the robot automatically returns for deep cleaning of the mop and self-cleaning of the dock.

If the problem persists after 10 minutes, the robot will automatically end mopping and return to the dock to.

If the problem is solved within 10 minutes, the robot will continue with mop washing.

Malfunctioning of the dock during mop washing will bring the mopping cycle to a halt.

The robot automatically resumes mopping upon completion of mop washing. You can adjust this interval in the app, or press and hold the Dock button to perform mop washing manually. The robot automatically returns for mop washing every 10 minutes by default. In so doing, the robot mops all zones one by one, efficiently cleaning the house. It splits a room into zones, first draws out zone edges, and then fills the zone in a zigzag pattern. The robot will plan its mopping route according to its scan of the room.

Do not use hot water as this may cause the tank to deform.

To prevent corrosion or damage, do not use cleaning fluid or disinfectant not specified by Roborock in the water tank.

Tighten the port cover and fit the water tank back in place. Take out the clean water tank and remove the filling port cover.

If the battery runs low during the vacuuming or mopping cycle, the robot will automatically return to the dock.Īfter charging, the robot will resume where it left off.

If vacuuming or mopping is completed in less than 10 minutes, the area will be cleaned twice.

Loose cables may be dragged by the robot, resulting in the disconnection of electrical appliances or damage of cables and property.

Before cleaning, tidy cables (including the power cable of the dock) and valuables from the floor.

Allow the robot to charge before starting cleanup. Vacuuming or mopping cannot start if the battery level is too low.Please vacuum the floor regularly to ensure satisfactory cleaning performance. The mopping feature cannot clean up large particles.To prevent excessive dirt buildup on the mop, floors should be vacuumed at least three times before the first mopping session.If you want to reconnect, reset the WiFi before proceeding. If the robot waits more than 1 hour for a connection, WiFi will be automatically disabled.Follow the instructions provided in the app. The actual process may vary due to ongoing app updates.On the homepage of the app, tap “+” in the top right corner and add the device according to the in-app guide.